Tech Article – Rear Swing axle boots replacement
Place jack-stands securely under the vehicle after raising it.
Take off the hose clamps from both ends of the old boot and cut it off (but don’t bother to remove the screws that attach the seam).
Wipe off the axle tube retainer and the axle tube.
Put on a thin layer of sealing compound to the mating surfaces of the new boot.
Slip the new boot into place, carefully. Be sure not to get oil on the mating surfaces of the seam.
Parts you might need – link to category Axle Boots
Squeeze the mating surfaces together at the seam and install the screws, washers and nuts after making sure the axle tube is level and the boot isn’t distorted.
The seam of the boot should point to the front or rear of the vehicle – not straight up. Now put in the hose clamps at each end.
Caution: If you over-tighten the fasteners, they will distort the boot and cause leaks, so be sure to use discretion.
Take out the jack-stands and lower the vehicle.